
4 Outstanding Interior Painting Tips to Add Spaciousness To Your Small Room
September 17, 2015
Exterior Painting Season coming to an END……We Can HELP
September 23, 2015The success of any painting project depends on the clean, smooth surfaces. However, the truth is, if your Andover, MA area home has been lived in by many people, your drywall would likely to receive many imperfections and even holes. Your drywall may be damaged by many reasons – it may the fixtures or furniture moving mishaps. Drywall holes are something that happens to even the most careful homeowners.
Before you call the professional painter services in Andover MA, here are few tips that help you repairing your drywall and make it great for the paint job.
Consider the Size of the Holes:
You should be careful about the size of the holes on your drywall. Before you use a knife or spackle, check how big is the hole you are repairing. Small holes can be fixed quickly and can be recovered in your favorite paint colors in no time. For repairing small holes of your drywall, you just need to clean the hole with a small knife and fill the hole with painter’s putty. You need to make sure that the hole is even with the surface of the wall once it is filled. Once the hole is dried, use a sand paper to make it smooth and spackle over the whole area using a putty knife.
Repairing the Medium Holes:
Medium holes happen as a result of removing the fixtures or when wiring is redone behind the wall. In order to fix medium holes, you need to use a drywall patch. First, use sandpaper to sand the area around the hole until it becomes smooth. After that you need to apply drywall patch by peeling off the paper backing. You can press it in place firmly with the mesh that is facing outwards. Next, spread the drywall compound over your patch. This will make your wall paint blend seamlessly. Sand it smooth when the compound is dried properly.
Fixing the Large Holes:
While large holes are difficult to fix, you can repair the large holes by following some useful tips. First, you need to cut a square around the hole by using a knife. The size should be even and easy to measure and repair. After that, you need to cut a piece of drywall according to the size of your hole and screw it into the backing stud. You need to fill the gaps with drywall tape and smoothing over it with drywall joint compound.